Model : P40NC Pillar Drill Machine
Uniquely designed to maximise productivity “PRAKASH” P40NC machine combines multiple
operation in a single setup, our customer have benefited by upgrading from their conventional
process of Drilling to over NC machines resulting in improved accuracy and reduced cycle time
thereby enhancing productivity and quality.
P40NC Key Features:
Increased Feed rates –6 Steps upto0.5 mm/rev
Auto Drilling as per G83 cycle for CNC
Set Tool offset
Can be used with U-drill for high speed and high speed
Auto Retract of drill to remove chips
Give No of passes for drilling as required
Manual, Auto and Peck cycles
Rapid Feed rate for fast settings
Key Features:
9 Spindle speeds with single speed motor
Hardened Gears
Hardened & Ground Spindle, RAM, Pinion
160 mm Column Dia
Single Piece column and table Bracket
Oil bath Gear Box:
Autofeed gear box used in Machine R40AA, R40BA & P40AA is having gears made up of NiCr Steel with heavy 2.5 module. All gears are also hardened. Two worm gears are made up of heavy duty 2.82 module teeth. All the shafts in the Gear Box are supported through good quality bearings and not the Bushes. Engaging Of Autofeed through TAPER CONE MECHANISM as in the lathe machines enables maximum loading capacity leaving behind other machines.
Specifications:
| Description | P40NC | |
| CAPACITY | Drilling in M.S. | 40 |
| Drilling in C.I. | 45 | |
| Tapping in M.S. | 25 | |
| Rough Boring in M.S. | 75 | |
| Spindle Travel | 250 | |
| DRILL HEAD | Spindle Hole taper | MT -4 |
| Spindle Speeds (RPM x steps) | 70-1225 x 9 | |
| Diameter of RAM | 78 | |
| Autofeed Ranges (mm/rev.) | any | |
| WORKING RANGE | Max/ Dist. Spindle nose to Table | 575 |
| Spindle centre to column | 345 | |
| Machine Measurement (LxBxH) | 880x850x2100 | |
| Diameter of Column | 130 | |
| Work Table | 450×455 | |
| Spindle Servo | 1 kw/2000 RPM | |
| Mitushubishi | ||
| HMI | Mitushubishi | |
| Contactors | Mitushubishi | |
| Drill Head Motor | 3 HP /960 RPM |
Standard Accessories:
Electrical Panel Board & Switches
Electrical Motors (Hindustan)
Extra Accessories:
Big Coolant tank & Pump
Through Coolant U-Drill Holder
Drill Chuck & Arbor
Keyless Drill Chuck & Arbor
P40NC Key Features:
Increased Feed rates –6 Steps upto0.5 mm/rev
Auto Drilling as per G83 cycle for CNC
Set Tool offset
Can be used with U-drill for high speed and high speed
Auto Retract of drill to remove chips
Give No of passes for drilling as required
Manual, Auto and Peck cycles
Rapid Feed rate for fast settings
